Midea SBS Error Codes
| Error Code | Description | Solution |
|---|---|---|
| E0 | Icemaker Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E1 | Refrigerator Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E2 | Freezer Duct Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E3 | Variable Compartment Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E4 | Refrigerator Defrost Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E5 | Freezer Defrost Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E6 | Communication Error | Check wiring between main PCB and display PCB. |
| E7 | Ambient Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E8 | Variable Compartment Defrost Sensor Error |
– Check the temperature sensor for damage. Replace if necessary. – Inspect the wiring for any loose or broken connections; repair if needed. – Check ohm on multimeter; value should be 1 (open) or 0 (short). |
| E9 | Freezer No Cooling Alarm |
– Check if the compressor is running. – Inspect for gas leakage or blockage. |
| EE | Icemaker Unit Error (including PCB) | Replace the icemaker and/or main PCB. |
| EF | Water Tank Not Fitted Properly | Remove and refit the water tank, ensuring it is aligned with the slots correctly. |
| CA | Communication Error between Main PCB and Icemaker PCB | Check wiring between the main PCB and the icemaker PCB. |
Post Disclaimer
The content provided by MBMTech Services is for informational purposes only. While we strive to ensure the accuracy of the information and instructions, repairs and troubleshooting procedures can be complex and may vary depending on the specific product, model, or situation. Attempting to repair electronic devices or products yourself carries the risk of further damage, injury, or voiding warranties. MBMTech Services is not responsible for any damage, loss, or injury that may occur as a result of following the advice, instructions, or techniques presented in our videos or content. We strongly recommend consulting a professional technician for repairs or technical support. Use the information at your own risk.