Haier Microwave Oven Error Codes
| Error Code | Description | Solution |
|---|---|---|
| E1 | Temperature sensor malfunction | Inspect the temperature sensor and replace it if necessary. |
| E2 | Door not closed properly | Ensure the door is fully closed and the latch is functioning correctly. |
| E3 | Power supply voltage issue | Check the power supply for stability. Contact an electrician if the issue persists. |
| E4 | Microwave overheating | Allow the microwave to cool down and ensure adequate ventilation. Restart after cooling. |
| E5 | Control board malfunction | Unplug the microwave for a few minutes to reset it. If the error continues, consider replacing the control board. |
| E6 | Magnetron failure | Inspect the magnetron for defects. If faulty, it will require professional replacement. |
| E7 | Turntable motor problem | Check the turntable motor and replace it if it’s not functioning properly. |
| E8 | Humidity sensor error | Clean or replace the humidity sensor if it is defective. |
| E9 | Fan malfunction | Ensure the cooling fan is working. Clear any blockages, and replace if needed. |
| E10 | Communication error | Reset the microwave by unplugging it. If the error persists, contact a technician. |
Post Disclaimer
The content provided by MBMTech Services is for informational purposes only. While we strive to ensure the accuracy of the information and instructions, repairs and troubleshooting procedures can be complex and may vary depending on the specific product, model, or situation. Attempting to repair electronic devices or products yourself carries the risk of further damage, injury, or voiding warranties. MBMTech Services is not responsible for any damage, loss, or injury that may occur as a result of following the advice, instructions, or techniques presented in our videos or content. We strongly recommend consulting a professional technician for repairs or technical support. Use the information at your own risk.