Voltas Dishwasher Error Codes and Solutions
| Error Code | Description | Solution |
|---|---|---|
| E1 | Water Inlet Error | Check that the water tap is open and the inlet hose is connected properly. Inspect for any kinks or blockages in the hose, and replace the inlet valve if it’s faulty. |
| E2 | Water Drain Error | Ensure the drain hose is free from clogs. Check the filter and drain pump for any blockages, and clean or replace them if needed. Replace drain motor if found faulty. |
| E3 | Overflow or Water Leakage | Inspect for any leaks inside the dishwasher. Check seals, hoses, and connections, and make sure they are secure. Replace damaged parts if required. |
| E4 | Heater Error | Check the heating element and wiring. Replace the heating element if it’s not working properly or shows signs of damage. |
| E5 | Temperature Sensor Error | Inspect the temperature sensor or thermistor. If the sensor is defective, replace it. |
| E6 | Door Lock Error | Ensure the door is closed completely. Inspect the door latch and lock mechanism; replace the door switch if it’s malfunctioning. |
| E7 | Water Level Sensor Error | Check the water level sensor for correct operation. Replace if the sensor is defective or giving inaccurate readings. |
| E8 | Spray Arm Malfunction | Inspect the spray arm for blockages or damage. Clean any blockages and make sure the spray arm rotates freely. Replace if necessary. |
| E9 | Circulation Pump Error | Check the circulation pump for blockages or mechanical issues. Replace the pump if it is faulty or not functioning. |
| F1 | Motor Error | Inspect the motor and associated wiring. If the motor is not working, it may need to be replaced. |
| F2 | Short Circuit Error | Inspect internal wiring for any damage or loose connections. Check the control board and other components for signs of short circuits; consult a technician if necessary. |
| F3 | Electrical Error | Check the power supply and internal wiring. This error may require the assistance of a professional technician to troubleshoot. |
| U1 | Low Water Pressure Error | Check that the water supply pressure is sufficient. Ensure the inlet hose is not kinked or clogged, and that the water tap is fully open. |
| U2 | Excess Detergent or Foam Detected | Ensure the correct amount of detergent is used. Clean the dishwasher interior to remove excess foam, and consider using a rinse aid to help control suds. |
| U3 | Filter Blockage | Remove and clean the dishwasher filter to prevent clogs. Regular cleaning can help avoid this error. |
| U4 | Load Imbalance Error | Check the placement of dishes to ensure even distribution. Avoid overloading, which can impact cleaning efficiency and cause imbalance. |
- Appliances Accessories online purchase
- washing machine cleaning procedure
- Smart Dignosis tool for refrigerator
- Samsung French door and Side by side dignosis
- washing machine troubleshooting without knowing error codes All brands
© 2024, mbmtech.in. All rights reserved.
Post Disclaimer
The content provided by MBMTech Services is for informational purposes only. While we strive to ensure the accuracy of the information and instructions, repairs and troubleshooting procedures can be complex and may vary depending on the specific product, model, or situation. Attempting to repair electronic devices or products yourself carries the risk of further damage, injury, or voiding warranties. MBMTech Services is not responsible for any damage, loss, or injury that may occur as a result of following the advice, instructions, or techniques presented in our videos or content. We strongly recommend consulting a professional technician for repairs or technical support. Use the information at your own risk.