Sansui microwave oven error codes

Sansui Microwave Oven Error Codes

Sansui Microwave Oven Error Codes

Error Code Description Solution
E1 Temperature sensor malfunction Check and replace the temperature sensor if necessary.
E2 Door not closing properly Ensure the door is fully closed and the latch is working correctly.
E3 Control panel error Reset the microwave by unplugging it for a few minutes. If the problem persists, consult a technician.
E4 Power supply issue Check the power source and make sure the voltage is correct. If the problem continues, contact support.
E5 Magnetron overheating Let the microwave cool down. If the error persists, the magnetron may need to be replaced.
E6 Internal communication error Reset the microwave by unplugging it. If the problem persists, seek professional repair services.
E7 Turntable motor malfunction Inspect the turntable and motor. Replace the motor if found faulty.
E8 Humidity sensor issue Check the humidity sensor and replace it if necessary.
E9 Ventilation problem Ensure the ventilation openings are not blocked and clean any dust or debris.
EA Clock setting error Reset the clock and ensure it is set correctly.
EC General system error Perform a hard reset by unplugging the microwave. If the issue persists, consult customer support.
Post Disclaimer

The content provided by MBMTech Services is for informational purposes only. While we strive to ensure the accuracy of the information and instructions, repairs and troubleshooting procedures can be complex and may vary depending on the specific product, model, or situation. Attempting to repair electronic devices or products yourself carries the risk of further damage, injury, or voiding warranties. MBMTech Services is not responsible for any damage, loss, or injury that may occur as a result of following the advice, instructions, or techniques presented in our videos or content. We strongly recommend consulting a professional technician for repairs or technical support. Use the information at your own risk.