Midea washing machine error codes

Midea Washing Machine Error Codes
Error Code Description Possible Cause Solution
E1 Water Supply Error Water supply is turned off or hose is blocked. Ensure the water tap is open and check the hose for blockages.
E2 Drainage Error Drain hose is clogged or the pump is malfunctioning. Inspect the drain hose for clogs and clean the pump.
E3 Door Lock Error The door is not securely locked during operation. Ensure the door is fully closed and verify the lock mechanism.
E4 Unbalanced Load Error Clothes are unevenly distributed in the drum. Redistribute the load evenly in the drum to balance it.
E5 Temperature Sensor Error Temperature sensor is malfunctioning. Inspect and replace the temperature sensor if necessary.
E6 Motor Error Motor overload or malfunction detected. Reduce the load and check motor connections for issues.
E7 Overflow Protection Error Water level exceeds safe limits. Check the water inlet valve and drainage for leaks.
E8 Heating Error The heating element is not functioning properly. Inspect and replace the heating element if necessary.
E9 Water Level Sensor Error Malfunction of the water level sensor. Clean or replace the water level sensor as required.
F1 Communication Error Problem with communication between the control board and motor. Check wiring connections and replace the control board if required.


Error Code: E10
Description: Water inlet error
Solutions:
Check water supply
Check inlet filter
Check inlet valve resistance (3k to 5k)
Check voltage on inlet valve
If voltage is available, replace the valve
If voltage is not available, replace the main PCB

Error Code: E12
Description: Overflow error
Solutions:
Check pressure sensor pipe blockages
Check if the inlet valve cuts off after the drum is filled
If cut-off is not working, replace the inlet valve
Otherwise, replace the pressure sensor

Error Code: E21
Description: Drain issue
Solutions:
Check blockages in the drain pipe
Check if the drain motor is faulty
If not, the main PCB may be faulty

Error Code: E30
Description: Door not closed
Solutions:
Check the door switch
Check the supply from the main PCB
If the supply is OK, replace the door switch
If supply is not available, replace the main PCB

s.

Post Disclaimer

The content provided by MBMTech Services is for informational purposes only. While we strive to ensure the accuracy of the information and instructions, repairs and troubleshooting procedures can be complex and may vary depending on the specific product, model, or situation. Attempting to repair electronic devices or products yourself carries the risk of further damage, injury, or voiding warranties. MBMTech Services is not responsible for any damage, loss, or injury that may occur as a result of following the advice, instructions, or techniques presented in our videos or content. We strongly recommend consulting a professional technician for repairs or technical support. Use the information at your own risk.